24
4.11. Removing a print stuck to the bottom of the tank
In case the first layer did not stick to the print platform, it remained
stuck at the bottom of the
tank.
No matter how big or how small the stuck layer is, there’s a quick safe way that will help you
remove it from the FEP film without damaging it - see chapter
15.1 - Removing an object stuck to
the bottom of the tank.
4.12. Removing supports
Supports for SLA printers are designed to be
thin, yet strong enough
to support the printed
material. The end of support is called a support head which is usually even thinner than the rest of
the support, which makes them
easy to remove,
leaving little to no trace on the object itself.
However, heavier or larger objects
may require stronger (thicker) supports.