R44-2018
11
IBM I
NTERFACES
IBM 4682/92 Port E Interface Selection
Scan this bar code to enable the IBM 468x/9x Port E interface (do not scan the SET
bar code before, or the END bar code after scanning this bar code).
IBM 4682/92 Port E Settings
Data Format: Send As Code 39 — converts bar code data (UPC/EAN, add-ons,
Code 93, Codabar, MSI/Plessey and Code 128) into Code 39 format before sending
the data to the host.
These settings are for IBM 4682/92 Port E interface ONLY.
Limit Command Set — tells the scanner to ignore 'enable scanner' and 'disable
scanner' commands sent from the host.
Transmit Unsolicited Status
1
— when enabled, the scanner transmitS a status
message to the host upon receipt of an "SNRM".
SET --------------------------------------------------
-------------- S
END
AS
C
ODE
39
D
ON
'
T
S
END
AS
C
ODE
39 ----------------
--------------- E
NABLE
L
IMIT
C
OMMAND
S
ET
D
ISABLE
L
IMIT
C
OMMAND
S
ET
------------
--------------- T
RANSMIT
U
NSOLICITED
S
TATUS
D
ON
'
T
T
RANSMIT
U
NSOLICITED
S
TATUS
-------------
----------------------------------------------- END
1
For this IBM interface, the setting for Unsolicited Status is normally Disabled.
D
ATA
F
ORMAT
