64
QuickScan™ 1000 Programming Guide
S
YMBOLOGY
S
ELECTION
Setting Interleaved 2 of 5 Fixed and Minimum Label Lengths
All interfaces that are shipped with the standard factory configuration are set to read
variable length labels. If you switch from variable to fixed length labels (by disabling
variable lengths on the previous page), the default fixed label lengths are 14 digits and
8 digits. Follow the steps below to change these defaults. All fixed length settings
for Interleaved 2 of 5 must be an even number.
Set Fixed
1.
Identify the fixed length settings you want to make.
2.
Scan the SET label.
3.
Scan the ENABLE FIRST FIXED barcode.
Setting Fixed Lengths
If you are setting a length less than ten, you must scan a zero first and then the length
digit ( 04, 06, 08).
4.
Set the first fixed label length by scanning the correct digits from the
next two pages.
If you need to set a second fixed length, continue with step five. If you
do not need to set a second fixed length scan the NO SECOND
FIXED LENGTH below and skip to step seven.
5.
Scan the SET SECOND FIXED label.
6.
Set the second fixed label length by scanning the correct digits from this
page.
7.
Scan the END label to complete the procedure.
Setting Minimum Label Length
1.
Identify the minimum length setting you want to make. The selectable
range is 04 to 50 characters
1
.
2.
Scan the SET label.
3.
Scan the SET MINIMUM LABEL LENGTH barcode.
If you are setting a length less than ten, you must scan a zero first and then the length
digit ( 04, 06, 08).
4.
Set the minimum label length by scanning the correct digits from the
next two pages
5.
Scan the END label.
1
The scanner will decode up to 50 characters, but the actual length read will vary
depending upon bar code size and quality. The IBM POS interface is limited to 32
character labels.