10
9
9
8
8
7
7
6
5
1
1
6
10
11
18
13
13
12
12
10
Diagram #3 – Stand Assembly
C.
Next, then attach the upper horizontal supports (10) using M8 x 20 carriage bolts (18) through
followed by 8mm washer (14), follow with 8mm lock washer (17), then M8 nut (15). One support is for
front; two are used for the back. The third upper support brace is attached at the highest holes of the long
vertical supports (6). The two back upper supports (10) are used accommodate filter brackets (11 & 16).
D.
Attach the filter brackets (11 & 16) using M8 x 20 carriage bolts (18) through followed by 8mm wash-
er (14), lock washer (17) and M8 nut (15). Next, attach the bracket arms (13) to the filter brackets with
M8 x 20 carriage bolts (18) through by 8mm washer (14), 8mm lock washer (17) and M8 nut (15). You
need to mount the filter support rods (12). NOTE: one support rod is at the furthest hole and one
support rod in middle of arm. See Diagram 3. Before attaching filter support rods (12) place one M8 nut
(15) before inserting to the bracket arms (13). Once rod is in place then follow with 8mm washer (14),
8mm lock washer (17) and add M8 nut (18) but do not tighten until filter cartridge (51) is in place.