Appendix C: Bar Code Settings
Decoded (ISCP) – Options
Psion Teklogix NEO Hand-Held Computer User Manual
C
-19
C.2.1
Decoded (ISCP) – Options
Laser On Time
The value assigned to this parameter determines how long the laser will remain on when the
scan button or trigger is pressed.
Double-tapping on this parameter displays a dialog box in which you can enter a value
between
1
and
10
seconds.
C.2.2
Decoded (ISCP) – Advanced Options
Continuous Scan Mode
Setting this parameter to
on
keeps the laser on and continuously decoding as long as the
scanner button is pressed and held down.
Minimum Cancel Time
The value assigned to this parameter determines the time delay before the scanner is turned
off, once the scanner trigger or button is released. This gives the scanner a minimum amount
of time to complete its current decode before the scan is cancelled when the user quickly
triggers on/off.
Low Power Timeout
To extend laser life, you can select the length of time the scanner remains active following a
successful decode. The scanner wakes from low power mode when a bar code is scanned – a
successful decode restores normal blinking.
When you double-tap on this parameter, a dialog box is displayed in which you can choose a
value of
30 sec, 1 min, 2 min
, or
3 min
.
Parameter Scanning
Setting this parameter to
Enabled
allows decoding of parameter bar codes.
Same Read Validate
The data is only transmitted after repeated reads give the same result. The value assigned at
this parameter determines the number of reads required, from
0
to
10
times.
Note: This parameter is only used if the Trigger Mode has been set to
Continuous On
and
the hand-held is mounted in a fixed position; otherwise, ‘Low Power Timeout’ is
not used.
