Chapter 2: Basic Checkout
Switching the Unit Off (Suspend)
12
Psion Teklogix NEO Hand-Held Computer User Manual
•
Replace the battery cover, and snap it into place.
To switch NEO on:
•
Press and hold down the [ENTER] key for at least one second.
•
When the LED flashes green, release the [ENTER] button.
The desktop screen is displayed.
2.2.2
Switching the Unit Off (Suspend)
•
Press the [FN/BLUE] key, and then press [ENTER].
2.3
Calibrating the Touchscreen
The touchscreen is factory-calibrated and ready-to-go; however, over time the touchscreen
operating parameters may change, and may need to be recalibrated for correct operation.
Refer to “Calibrating the Touchscreen” on page 36 for details.
2.4
Wireless Networking
NEO contains an integrated 802.11b/g radio module. The
Wi-Fi Config
application is used
to configure NEO for one or more wireless network profiles. A network profile contains set-
tings for SSID (Service Set Identifier) and security options.
Note: If you are using a docking station or an external power supply, you can insert an
uncharged battery and switch NEO on.
Note: If the unit was already in use – the unit may be off (suspend state) – pressing
[ENTER] ‘wakes’ the unit from this state. The screen in which you were working
prior to the suspend state is displayed.
Note: Keep in mind that the touchscreen function can be turned off (see “Touch” on
page 97).
Note: In most situations, the configuration of your 802.11 radio will require parameter set-
ting and access keys from a network administrator.
