∗
Warning:
Moving parts can injure, make sure hands are not near belt at this time.
1.09 Move belt clamp control to tighten position.
1.10 The cylinders will tighten the belt around the hose.
1.11 If the hose is not securely held return the control to release position and return to step
1.07.
1.12 Place the fitting to be pushed into the hose and secure by pushing partially into hose.
1.13 Using the hand wheel located on top of the pusher slide, raise or lower the pusher plate
to align with the fitting.
∗
Warning:
Moving parts can injure,
make sure hands are not near the fitting or pusher
plate at this time.
1.14 Slowly move the pusher control to insert position, watching to assure the fitting pushes
evenly into the hose.
∗
Notice:
In the event that the fitting contacts the belt holding block prior to full insertion,
repeat the hose holding and insertion sequence. You may wish to reposition the hose
further through the belt and continue.
1.15 Once the fitting is fully inserted return the pusher control to neutral (center) position, then
retract the plate fully by moving the pusher control to retract position.
1.16 When the plate is fully retracted return the pusher control to neutral (center) position.
1.17 Move the belt clamp control to release position and remove the hose and fitting from the
unit to complete the coupling process.
1.18 For additional hoses return to step 1.05.
REV. 7/12/15
