150M Wireless N ADSL2+ Router
- 91 -
4.3.4 Wireless Bridge
Wireless Distribution System is used to extend the existing wireless
signal coverage. Wireless bridge includes 2 modes:
1. Access point (Once it is selected, the AP function will be enabled
while wireless bridge function will be reserved. And wireless base
station will establish bridge with the AP in the meantime. Namely, you
can establish communication with wireless base station through a
wireless network adapter) as shown in the figure below:
In the above figure, 2 W150Ds are used to enlarge wireless signal
coverage. W150D-2 is configured as a wireless access point to
establish a wireless bridge with W150D-1. In the meantime, the AP
function reserved in W150D-2 enables PC3 and PC4 to communicate
with W150D-2 and access Internet through wireless network adapters.
2. Wireless bridge (Here in this mode, wireless is used as pure bridge
only with no more AP function to connect and communicate with remote
devices. Namely, your PC can only be connected to the device via
wired media instead of communicating with the device through wireless
network adapter.) see the figure below:
