Digital Conference System (D-3002)
Figure 4-29 Adjusting All Mic/ Active Mic Gain
e) Unit Volume Setting
Adjust the microphone’s volume for all discussion units synchronously.
Use Up and Down button to switch to “Unit Volume” in Figure 4-24, press Enter button
to enter the following interface:
Figure 4-30 Adjusting Microphone Volume
4.10.3 Voice Mode
Use Up and Down button to switch to “3. Voice Mode” in figure 4-22, press Enter to
enter into auto closing time setting interface shown as below:
Figure 4-31 Auto Closing Time Setting
When a delegate unit finished speaking, and didn’t manually turn off the mic, given the
silence time exceeds the value set in Auto Closing Time Setting, the mic will be
automatically switched off. The value ranges from 01 to 15.
4.10.4 Address Setting
Step1.
Use Up and Down button to switch to “3.Address” in Figure 4-22, and then
press Enter button to enter into the following interface:
Figure 4-32 ID Setting
Step2.
Use Up and Down button to set the first ID (value ranges from 1 to 249), and
then press Enter button. Then it will set IDs for all the connected discussion
units automatically.
23
