Digital Conference System (D-3002)
Figure 4-33 ID State
Step3.
In ID setting state, all LED indicators on discussion unit will blink, please press
any button (but not the Priority button on chairman unit) to make D-3002 able
to recognize your unit and set ID for your unit.
Then the LED indicators will be off, and the LCD screen will show you the
message that your ID is successfully set. And the ID will be showed on the
control unit D-3002.
Step4.
After finishing setting IDs for all units, please press Exit button. Then the
control unit will automatically begin to initialize. After the initialization, it will
return to the Manually ID Setting interface.
4.10.5 System Parameters Setting
Use Up and Down button to switch to “System Param”, and then press Enter button to
enter into the following interface:
Figure 4-34 System Parameters
a) Set as factory default
Use Up and Down button to switch to “FactorySetting”, and then press Enter button to
enter into the following interface:
Figure 4-35 Set as Factory Default
Use Up and Down button to switch to “Yes” or “No”, and then press Enter button.
Note:
Only when the first ID is A001 and the A001 unit is a chairman unit, will this
chairman unit be able to control other units in off-line state.
24
