NOMEX
Operating Manual - NOMEX Multimeter Setup
D909.131.00/02 en
51
6.3.7 Start/Stop
The NOMEX multimeter is normally used in the
auto-start/auto-stop mode. If needed, a measure-
ment can be manually started and stopped when
the button for the manual start and manual termi-
nation of the measurement is visible on the mea-
suring window.
You can show and hide this button by
enabling and disabling the
Start / Stop
option.
NOTE
If you have disabled the
Start / Stop
option, the
Zeroing
button will be hid-
den in sensitivity mode
Normal
. Thus,
zeroing manually is no longer possi-
ble in this mode. For further informa-
tion, refer to section
Auto-Start/Auto-Stop:
The NOMEX multimeter is permanently in auto-
start mode. This means that a measurement
starts automatically when a signal is detected.
For dose measurements, the dose and time val-
ues are first set to zero (auto reset).
Manual Start/Stop:
When the
Start / Stop
option is enabled, the button
for the manual start and manual termination of the
measurement is visible on the measuring window.
Start measurement manually
Stop measurement manually
