NOMEX
Operating Manual - Measurements with the NOMEX Multimeter
D909.131.00/02 en
61
7.6
Loading Stored
Measurement Data
•
To load stored measurement data,
click the
Open
button or select menu
File
→
Open
.
•
Select the file to open from the standard
Open
dialog.
➔
NOMEX will check whether the application and
the measurement settings of the data to load
match the current settings.
•
If the application does not match, an appro-
priate message will appear. Confirm the mes-
sage with
OK
.
➔
The file will be loaded, overwriting the currently
displayed measurement data. If the currently
displayed data were not yet saved, a message
will appear and you can save them, if required.
➔
In the main data window, either the current
measurement will be highlighted in the mea-
suring table or the waveform graph of the cur-
rent message will be displayed.
➔
The measuring window will show the mea-
sured values of the current measurement.
•
By clicking the
Next
button
– the next measurement will be high-
lighted in the measuring table or
the waveform graph of the next
message will be displayed in the
main data window
– the measuring window will show
the measured values of the next
measurement.
•
By clicking the
Previous
button
– the previous measurement will be
highlighted in the measuring table
or the waveform graph of the pre-
vious message will be displayed in
the main data window
– the measuring window will show
the measured values of the previ-
ous measurement.
•
By clicking the
Reset measurement
or
by changes in the menu
Setup
(
Setup
button) all measured values will be set
to 0.
