28
v1_1 rev. 10-22
Video Mode
: Configure assorted video output
settings.
• SDI-3G Mode
: Set the SDI level.
Options include: Level-A, Level-B
• Video Output
: Set the video output to SDI
or HDMI.
Options include: HDMI, SDI
• DVI Mode
: define HDMI Data Transfer type.
Options include: HDMI, DVI
Other:
• Auto Inversion:
Toggle auto inversion.
Options include: Off, On
• Tally Mode:
Toggle the tally light
functionality. Options include: Off, On
• USB Audio:
Toggle USB audio embedding.
Options include: Off, On
• USB2.0 Function:
Define how the USB port
is used. Options include: UVC, Host
Communication Setup
Move the main menu cursor to
[Communication Setup]
and press [HOME] key enter Communication
Setup page, as shown in the following figure.
Communication
Setup
Protocol VISCA
V_Address
1
V-AddrFix
Off
Net
Mode
Serial
Baudrate
9600
[Menu] Back
Protocol:
Control protocol
Options include: VISCA, PELCO-D,
PELCO-P, Auto
V_Address:
VISCA protocol camera address
Options include: 1 ~ 7
V-AddrFix:
When enabled, the Visca address will
not change. Options include: Off, On
Net Mode:
Control type
Options include: Serial, Paral
Baudrate:
Baudrate control speed
Options include: 2400, 4800, 9600,
38400
P_D_Address:
Pelco-D protocol address
Options include: 0 ~ 254
P_P_Address:
Pelco-P protocol address
Options include: 0 ~ 31
Restore Default
Move the cursor to the “Restore Default” option
and press the [Enter] button to enter the Restore
Default page, as shown in the figure below.
Restore
Default
Press [Enter]
Confirm
Press [Back]
Cancel
Select [Enter]
[Menu] Back
Note: Press the [Enter] button to confirm.
All camera parameters will return to default,
including IR remote & VISCA Addresses.
