4
THERMAL IMAGING SCOPE
HELION 2 XP50 PRO
EXTERNAL VIEW AND CONTROLS
1.
Lens cover
2.
Lens focus ring
3.
Battery Pack
4.
Micro-USB connector
5.
Eyeshade
6.
Diopter adjustment ring
7.
Record button REC
8.
Navigation button DOWN
9.
Button MENU
10.
Navigation button UP
11.
Activation / calibration button ON
12.
Latch for lens change
13.
Lever for Battery Pack
14.
Tripod socket
DESCRIPTION OF CONTROLS
Button
Device status
First short press:
Other short presses Long press:
Button
ON / OFF
(11)
Device is off
Power device on
Microbolometer
calibration
Turn display off / Power
device off
Display OFF mode
Turn display on
Microbolometer
calibration
Device is on
Microbolometer calibration
Navigation
button
UP (10)
Regular (observation) Switch observation modes
Switch colour palettes
Main menu
Navigation up / right
Quick menu
Change parameters
Button
MENU
(9)
Regular (observation) Enter quick menu
Enter main menu
Main menu
Confirm selection
Exit submenu without
confirming selection
/ Exit menu (switch to
observation mode)
Quick menu
Switch between quick menu options
Navigation
button
DOWN (8)
Regular (observation) Control discrete zoom
PiP on / off
Main menu
Navigation down / left
Quick menu
Change parameters
Record
button
REC (7)
Video
Start video recording Pause / resume video
recording
Stop video recording /
Switch to photo mode
Photo
Take a photograph
Switch to video mode
USING THE BATTERY PACK
Helion 2 PRO thermal imaging scopes are supplied with a rechargeable Li-Ion Battery Pack IPS7 which allows
operation for up to 8 hours. Please remember to charge the Battery Pack before first use.
CHARGING
•
Lift the lever (C) of the charging base.
•
Remove the protective cover from the Battery Pack.
•
Insert the battery into the charger until it stops, as shown in Fig., lower the lever (C).
•
Upon installation, a green indicator (D) on the charger will start to glow and begin flashing:
द
once if the battery charge ranges from 0% to 50%;
द
twice if the battery charge ranges from 51 and 75%;
द
three times if the battery charge ranges from 76% to 99%.
•
If the indicator lights green continuously, the battery is fully charged. You can disconnect it from the charger.
•
To charge the battery, connect the micro-USB plug of the USB cable to port (E) of the charger.
•
Connect the plug of the USB cable to the mains adapter.
