8. MicroUSB connector
LED Indicator
Operating Mode
LED indicator displaying current status of the device
Device is powered on
Device on / battery charge <10%
9. Battery release button
7. Lens cap
1. Eyepiece dioptre adjustment ring
2. Down button
3. Menu button
4. Up/Zoom button
5. On/Calibration ON button
6. Lens focus ring
USING THE RECHARGEABLE BATTERY
Charging the battery
Option 1 (Fig.2) :
џ
Install the battery (10) into its slot on the instrument
case (14) by aligning the icons to form a 'dot' on the
device and the battery. (see Fig. 4).
џ
Attach a USB cable (15) to the microUSB connector
(8) on the device.
џ
Connect the other end of the USB cable (15) to the
mains charger (16) or to a USB socket connected to
another power source with rated output of 5V or less.
AXION KEY thermal imagers are supplied with a
rechargeable APS3 Lithium-ion Battery Pack which
enables the thermal imager to be used for up to 3
hours. The battery should be charged before first use.
џ
Connect the mains charger (16) to the mains power
supply.
џ
Point A on the battery and Point B on the charger
should be aligned.
џ
Two batteries can be charged at the same time – a
second slot is provided for this.
џ
Attach the microUSB plug on the USB cable (15) to
the microUSB connector on the mains device (16). Plug
the device into a 100–240V power outlet (17).
џ
Insert the rechargeable battery (10) supplied with
your device, or purchased separately, fully along the
guide rail into the APS charger slot
(а
vailable
separately
)
(11).
Note:
The PB8I* Power Bank may be used as a charger
(see Item 7).
Option 2 (Fig.3) :
Attention!
AXION KEY thermal imagers require a
licence when exported outside your country.
џ
Attach the second plug of the microUSB cable to the
socket (12) of the mains charger (11).
џ
The LED indicator (13) will light up.
COMPONENTS AND CONTROLS
BUTTON OPERATION
1
2
3
4
5
6
7
9
8
LED indicator
Fig.
1
2
