BLACKBOX 130 UL INSTRUCTION MANUAL
52
Remote Alarm
When a Modem is connected to the Blackbox, via the RS232 port, (Consult
Pulsar or your local distributor for further details), the following parameters
are used to set up the BlackBox so that when the level reaches a specific
alarm point, as determined by the setting of the relay(s) the unit will dial and
connect to a remote telephone number to provide details of the event.
P985 Tel. No.1
This parameter is used to
enter the number of ‘0’s that appear at the
beginning of the telephone number to be dialled that is to receive the
message.
OPTION
DESCRIPTION
0 = None
No ‘0’s present at the beginning of the telephone
number to be dialled.
1 = Add 0 (Default)
1 ‘0’
present at the beginning of the telephone
number to be dialled.
2= Add 00
2 ‘0’s present at the beginning of the telephone
number to be dialled.
P986 Tel. No2
This parameter is used to enter to enter the next
6 digits, following the ‘0’s,
of the telephone number to be dialled. If there are less than 6 digits
following the ‘0’s then just enter the digits required, if there are more than 6
digits following the ‘0’s then enter the first 6 digits and then proceed t
o
P987 and enter the remaining digits.
P987 Tel. No3
This parameter is used to enter any remaining digits of the telephone
number to be dialled after completion of P985 and P986 above.
Example
Telephone number to be dialled is: 0 1234 123456
P985 Tel. No.
1 = 1(One ‘0’ at the
beginning of the telephone number)
P986 Tel. No. 2 = 123412 (The next 6 digits following the ‘0’s).
P987 Tel. No. 3 = 3456 (Remaining digits of telephone number).
