PULSAR MEASUREMENT
79
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested before despatch to you.
To
reset
parameters, enter
1
(
Yes
), and press
ENTER
, then you will see a
message “
Entr if sure
”, you should press
ENTER
again. If you press any
other key at this point, the parameters will not be reset, and you will see a
message confirming this.
Once you have done this, program the unit, to the desired application.
Date & Time
P931 Date
This parameter shows the
current date
, in the format as set by
P933
(
Date
Format
) and can be reset if required.
P932 Time
This parameter shows the
current time
and can be reset if required, in the
format HH: MM (24-hour format). This is set initially at the factory for UK
time.
P933 Date Format
This parameter allows you to alter the format that the date is displayed to
your choice of DD: MM: YY, MM: DD: YY or YY: MM: DD. The default is DD:
MM: YY.
Daylight Saving Time
P970 DST Enable
When Enabled (set to 1) the internal clock will be automatically adjusted to
compensate for the difference between standard time and Daylight-Saving
Time.
OPTION
DESCRIPTION
0 = No
DST is disabled
1 = Yes
(Default)
DST in enabled
P971 DST Difference
This parameter sets the time difference between standard time and Daylight
Saving Time. The time difference is entered in HH: MM.
