Cover the terminals with the rubber covers
When removing the battery for replacement: Remove the nut and bolt first from the negative (Black) post, then from the
positive (Red) post, being careful not to short across the terminals. Always abide by the safety warnings provided with the
battery. Remove the battery and dispose of it according to your local and state regulations.
Attaching Battery Cable (See fig 3)
11
ASSEMBLY
Be careful not to short across the terminals when installing. Shorting the terminals together
can cause sparks, damage to the battery or generator, or even burns or explosions.
CAUTION!
• Always wash hands after touching battery.
WARNING!
Battery posts, terminals, and accessories contain lead and lead compounds known to cause
cancer and reproductive harm.
NON-SPILLABLE
SEALED BATTERY
This is a ready filled,
activated sealed battery.
Never remove strip.
Refer to owner’s manual
or instruction sheet for
charging procedures.
l
!
DANGER/POISON
SHIELD
EYES.
EXPLOSIVE
GASES CAN
CAUSE BLINDNESS
OR INJURY
NO
SPARKS
FLAMES
SMOKING
SULFURIC
ACID
CAN CAUSE
BLINDNESS OR
SEVERE BURNS
FLUSH EYES
IMMEDIATLEY
WITH WATER
GET
MEDICAL
HELP
FAST
WARNING!
PROPOSITION 65
WARNING
Battery posts,terminals,and related
accessories contain lead and lead
compounds,chemicals known to the
State of California to cause cancer and
reproductive harm.
Wash hands after handling.
Wear Eye Protection
Never Reverse Pole Connections
Never turn the battery upside down
DO NOT Smoke near the battery
If electrolyte contacts the skin wash the area immediately with clean water
If electrolyte contacts your eye, rinse immediately with clean water
and seek medical attention
NOTICE:
If the Generator is stored for over six months the battery will need to be and charged.
Pb
•
•
•
Locate the pigtail harness already attached to the battery (-) negative post
Ensure the hardware is tight and the red rubber boot is fitted over the (+) battery
connection
Align the male and female battery cable connectors and firmly fit them together
