www.pulsar.pl
RUPS812P
RACK POWER
3
1. Technical description.
1.1. General description.
The RUPS812P buffer power supply unit is designed for uninterrupted power supply of up to 8 analog
cameras requiring stabilized voltage of 12V DC(+/- 15%). The PSU provides voltage of U=13,8V DC. Current
efficiency:
Output current 8A + 1A battery charge.
Total device c battery: 9A max.
In case of power decay, a battery back-up is activated immediately. The PSU is fitted with 8 outputs
protected independently with polymer fuses 1A. The power supply is fitted with the ALARM output of collective
failure. In case of failure, relay contacts are switched automatically, which is accompanied by acoustic and optical
indication (the corresponding led goes on). The power supply construction is based on the switch mode PSU with
high energy efficiency and is located in an enclosure adapted for mounting in standard RACK 19” cabinets.
1.2. Block diagram.
Fig.1. The block diagram of the PSU.
1.3. Description of PSU components and connectors.
Table 1. Components of the front panel of the power supply.
Element no.
[Fig. 2]
Description
AC OK – green LED, indicating the presence of 230V voltage
DC OK – green LED, indicating the presence of DC voltage
TEMP – red LED, indicating too high temperature of the power supply (>70°C)
LoB – red LED, indicating too low battery voltage (<11,5V)
LED ALARM – red LED failure indication
Green LED AUX1 ÷ AUX8 – voltage indication at the AUX outputs
AUX1 ÷ AUX8 – independently protected outputs
BAT – battery output
ALARM – technical output of collective failure – relay
BUZZER, micro switch, turning ON / OFF of acoustic indication
switch in the top position, indication ON
switch in the down position, indication OFF
230V AC INPUT, power socket 230V AC, power cable 1,5m included
F
MAINS
, fuse in the supply circuit 230V AC, T 3,15A/250V
