PULSAR MEASUREMENT
27
3.
Auxiliary Display, scrolling twelve-digit display.
Run Mode;
displays measurement units, status messages on signal
and transducer, details of Hot Key function selected. It can be also
programmed to provide notification messages on alarms and
pumps etc. For full details please refer to Display Parameters in the
relevant parameter listing.
Program Mode;
displays menu and sub menu headings, parameter
details and options.
4.
Communicator status, this displays the status of remote PC
connection and velocity sensor operation.
5.
Bar graph display, this gives visual indication of measurement in %
of span.
6.
Level indicators:
Run Mode;
indicates in which direction the level is moving.
Program Mode:
indicates at which level of the menu system you are
at.
There are two main operating modes for your Zenith 140,
Run Mode
and
Program Mode
. There is also a
Test Mode
, used for checking the set-up.
All modes are now described.
Run Mode
This mode is used once the Zenith 140 has been set up in program mode. It
is also the default mode that the unit reverts to when it resumes operation
after a power failure.
When the Zenith 140 is switched on for the first time, it will display, in
metres, the distance from the transducer face to the target. All relays by
default are switched off.
After programming is complete, any relays that are set will operate when the
level reaches the relevant setpoint, and the LED’s will change colour (unless
specifically switched off).
