19
which can ensure that milk collection kits are safe for use by multiple users.
The Milk Genie is a single-user pump.
Choose from any of the following instructions to sterilize pump parts:
Boiling
1.
Place all the equipment in a large sauce pan and cover with tap
water.
2.
Check that there are no air bubbles inside bottles or other parts.
3.
Place the lid on the saucepan and bring to a boil.
4.
Boil for 5 minutes, making sure that the pot doesn’t boil dry and
melt the equipment.
5.
Turn off the heat and allow to cool.
6.
Remove parts with tongs and air dry on a clean dish rack or clean
paper towel.
Chemical Solutions (i.e. Milton®)
Follow the directions to make up the chemical solutions. Always follow the
manufacturer’s directions if they differ from the information below.
1.
Make up a fresh solution every day.
2.
Make up the solution in a large, clean plastic container.
3.
Separate the equipment and place into the chemical solution,
squeezing the solution through the teats to make sure they are not
blocked.
4.
Check that there are no air bubbles inside the bottles.
5.
Completely cover the equipment in the chemical solution. If they
float to the top, place something heavy (like a plate) over them.
6.
Don’t put anything metal (knives, spoons) in the chemical solution.
7.
Remove and rinse off in cool water. Air dry on a clean dish rack or
clean paper towel.
Steam Sterilizer
Follow the manufacturer's directions.
Summary of Contents for Milk Genie
