21
If you purchased the
DP 01S kit (“Additional unit”)
, to make and receive
calls with your
DP 01S Handset
you first need to register it to your DP 01
Base station (“Main unit”) or to another DECT model base station. Please
refer to the “Registration” procedure explained under point “a” below.
Note: If another manufacturer’s products are connected to the
Punkt. DP 01 Base unit, only the ability to make and receive phone
calls is guaranteed according to the DECT-GAP standard. Proprietary
features (for example TAM service or CLI display) may not be
available if another manufacturer’s products are being used with
Punkt. products.
Registration:
a) To register a DP 01 or a
DP 01S
handset to the DP 01 Base unit, please
follow the procedure below.
–
On the DP 01 or
DP 01S
handset, press
F
, select ‘Handset settings’
and press
D
.
–
Select the ‘Registration’ option and press
D
.
–
Select ‘Base 1’ and press
D
if you have only one Punkt. Base unit
(DP 01 – “Main unit”) already available and switched on. If your
Punkt. handset was previously registered to another Base unit, you
can select ‘Base 2’ (or ’Base 3; 4’) to keep your handset’s previous
registration setting(s) with that base unit.
–
Insert the base PIN code (4 digits, default: 0000), then press
F
to
highlight the ‘Done’ option.
–
Press
D
. The message: ‘Press and hold page button on base’ will
appear on the display.
–
Hold down the page button on the DP 01 base until the display
shows the list ‘Handset 1,2,3,4,5,6’, then release the page button.
–
Select your ‘Handset number’ from the list that appears (default
selection: ‘Handset 2’), then press
D
to end the registration
procedure.
–
Once the registration procedure is finished, briefly press the page
button again on the base to check that all handsets registered to that
base ring at the same time when an incoming call is received.
b) To register a DP 01 or a
DP 01S
handset to the Base unit of a different
manufacturer (brand), you should first set the other manufacturer’s
Base unit to “Registration mode” (refer to the user manual for details).
Then, using your Punkt. handset, follow the registration procedure as
explained under paragraph “a” of this section.
c) To register another manufacturer’s handset to the Base unit of
the DP 01 (Main unit), begin the registration procedure with that
handset in accordance with the manufacturer’s instructions, then
hold down the “Page” button on your DP 01 Base unit for 5 seconds to
activate the registration procedure on the DP 01 Base unit. Finally,
complete the registration procedure on the other manufacturer’s
handset according to the manufacturer’s instructions.
Multi-Handset configuration
(setting up the DP 01S – “Additional unit”)
