7
Care of the product
Cleaning the product
Wipe the base and the handset with a damp cloth (do not use solvent) or an
antistatic cloth. Never use a dry cloth. This can cause static.
Contact with liquids
If the handset comes into contact with liquids:
–
Switch off the handset and remove the batteries immediately.
–
Allow the liquid to drain from the handset.
–
Pat all parts dry, then place the handset with the battery compartment
open and the keypad facing down in a dry, warm place for at least 72
hours (not in a microwave, oven, etc).
–
Do not switch on the handset again until it is completely dry.
–
When fully dried out, it will often be possible to use the handset again
although some problems could arise.
–
Oxidation caused by liquids such as water that has penetrated into the
phone can cause serious functional problems. Such problems are not
covered by the warranty service.
Product transportation
If transporting this product, use the original packaging to protect the
product from potential damage.
Wall-mounting solution
The base station can be mounted on a wall if preferred. A magnet in the
base station next to the charging contacts holds the handset vertically
during the charging phase. To ensure that the phone does not become
detached from its base and fall to the ground, make sure the handset is
properly seated on the base station before removing your hand from the
handset. Damage and/or broken parts due to user negligence in this
phase are not covered under the terms of the warranty.
