9
+
+
-
-
+
+
-
-
+
+
-
-
+
+
-
-
+
+
-
-
+
+
-
-
Installation
To install your Punkt. phone (DP 01 - “Main unit” or
DP 01S – “Additional
unit”
), please follow the steps below.
1 Remove the back cover of the phone (insert your finger in the opening
near the charging contacts and remove the battery flap).
2 Insert the batteries into the handset, then replace the cover (be sure to
observe the correct polarity indications (‘+’ and ‘-’) as shown inside the
battery compartment).
3 Insert the phone cable (for the DP 01 “Main unit” only, not for the
DP
01S - “Additional unit”
). The base unit of the
“DP 01S”
serves only to
charge the handset batteries. You therefore need only connect the
power adaptor cable to this base unit. You do not need to connect
the phone cable to the base unit of the
“DP 01S”
.
4 Insert the power cable (for both DP 01 and
DP 01S
models).
5 Connect to phone and power sockets. A specific adaptor for your phone
socket and/or your mains socket may be requested, depending on the
country you are in and the standard socket configuration.
6 Place the handset on the base for battery charging (a docking sound
indicates that the handset has been placed correctly on the base).
7 Let the batteries to charge for at least 16 hours before using your
phone for the first time. Subsequently, 8 hours will be sufficient for a
full recharge.
For DP01 Main unit only
For both the DP01 and DP01S
