Corporate
800.882.8854
33
System Start-up (Continued)
Checking For Leaks
There are several unions on the Reclaim Machine that should be checked for leaks. The
machine is “Wet Tested” and verified at the factory for function, leaks, etc. The unions are
loosened to drain down the system prior to shipment and should have been tightened earlier
in this process. Check all unions and fittings for leaks at this time.
Testing the Reclaim in “Auto”
The wash activation signal has already been
tested in the “Hand / Bypass” mode. The
machine should be idling in recirculation
mode once the priming has been completed.
The VFD speed is indicated in a percentage
& the delivery pressure is shown with the
Reclaim idling in Auto with no activation
signal present.
Once the Reclaim Machine is holding prime,
go ahead and initiate a car wash. The Touch
Screen will indicate that it is in Auto and will
also display “Activation On”.
Test all activations (if more than one is being
used). The Reclaim Machine is designed
to deliver reclaim product water at 40psi in
the designated volume based on the model
purchased. The variable frequncy drive
(VFD) will vary the pump motor speed up to
a maximum of 60 Hertz based on transducer
feedback. VFD speed is displayed in a
percentage and treated line pressure is
displayed in PSI (pounds per square inch)
Again, check all fittings and unions for leaks
at this time.
Reclaim Output Ratings
PW100 - 30gpm @40psi
PW200 - 60gpm @ 40psi
PW300 - 90gpm @ 40psi
PW350 - 120gpm @ 40ps
PW400 - 160gpm @ 40psi
Summary of Contents for PURWATER RECLAIM 3.0
Page 2: ...Corporate 800 882 8854 2...
Page 4: ...Corporate 800 882 8854 4...
Page 6: ...Corporate 800 882 8854 6...
