• When unplugging from outlet hold humidifier securely.
• Do not place cord over objects.
• Do not get water in or on the power cord or where it connects to the product. Do not use
near a sink.
• Do not touch the water tank during operation.
• Do not submerse the unit in water or pour water on the unit or in the humidity spout.
• When emptying water from water tank, pour on drain side.
• Do not cover the spout with cloth or hand and do not use without the spout.
• Use clean or distilled water in tank. Hard water areas will require more frequent cleaning.
Troubleshooting
Please refer to the table below in the event the product is operating abnormally.
Problem Solution
Water vapor and humidity
Power plug: Unplug and then try again.
are not produced.
Power failure: When power is returned, try again.
Tank installation: Make sure the tank is correctly attached.
The surface of the ultrasonic disk is dirty: Clean ultrasonic
disk.
Air blows but water vapor
Excessive water: Remove a certain amount of water
is not produced.
from the tank.
Detergent residue and/or oil ingredients from cosmetics,
etc. may be in tank; wash out tank and try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic
disk.
If you use hard water, replace with softer water.
Humidity level is low.
The surface of the ultrasonic disk is dirty: Clean ultrasonic
disk.
The water in the unit is too cold: Replace with cool water.
The humidity has a bad
Poor maintenance or dirty water: Clean the product
smell.
thoroughly, and fill it with fresh water.
White dust is forming on
Hard water may deposit a certain kind of dust. Dust in the
nearby furniture.
air also settles because of added humidity in the room.
Use distilled water if this becomes a nuisance.
7
