Follow instructions here,
in Owner’s Manual, or
pureAir3000.com/Clean
Clean
1. Unplug purifier. Remove Screw in
Rear Cover above Power Plug.
2. Remove Rear Cover by prying
sides loose and tilting up until free.
3. Remove Filter Assembly by
removing two brass thumbscrews.
Disassemble. Remove dust with running
water or vacuum. Dry before reassembly.
4. Remove PCO Cell by removing
two black thumb nuts. Unplug.
Clean with compressed air or vacuum
(no liquids). Do not disassemble Cell.
5. Remove Activated Oxygen Plate
by carefully sliding it out of place.
Soak for 12 hours in solution of equal
parts clear ammonia and water. Dry.
6. Clean Purifier inside and out with
damp cloth or compressed air.
If necessary, remove Front Grille by
removing screws at top and tilting out.
7. Ensure all components are dry.
Reassemble purifier in reverse.
8. Reconnect power and hold
“Reminder Reset” on Control
Panel until “Perform Cleaning”
disappears from Display.
