PureAire Monitoring Systems, Inc.
23
Push the joystick down to access the next sub menu;
Set 20mA Span will scroll.
This is the menu at which to adjust the 20mA output being sent from the Air Check
Monitor.
To change this value, push the joystick right to display the 20mA span setting. The
display will indicate a value between 0 and 255 counts. Pushing the joystick up
increases the value and pushing the joystick down decreases the value. The 20mA
output being sent from the Air Check monitor will change as the number on the
digital display changes. Press
ENTER
to accept the value.
Push the joystick to the left brings you back to the pervious Main menu. The digital
display will scroll the following:
Push the joystick down to access the next sub menu;
Force loop will scroll.
NOTE: This menu item is not available on the Carbonyl Sulfide monitor.
Push the joystick to the left brings you back to the pervious menu. The digital display
Will scroll the following:
4.6.2 Set Formats
This is the menu at which to adjust the relay states for the two gas alarm relays and
the individual instrument fault relay.
Push the joystick down to access the next main menu,
Set Formats.
The display will
scroll the following:
...Set 20mA Span…
2
0
.
9
%
255
2
0
.
9
%
...Set 4-20mA loop…..
20
.9
%
.…Force Loop….
2
0
.
9
%
...Set 20mA span…..
2
0.
9
%
