13
3-Levels Humidity LED Light
Besides the humidity digital display in the LCD, there is a 3-level LED light
through the tank window for easier monitoring the indoor humidity. Green light
represents humidity under 50%, blue light 50-65% and red light above 65%. You
can turn off or retrieve the light by pressing the MODE and HUMIDITY at the
same time.
Alarm
If the unit malfunctions, then an alarm will activate and the unit will
automatically shut down.
Internal Overheating Protection
During operation malfunctions may occur if the air intake or exhaust is
obstructed or blocked by objects. Do not obstruct or block the air intake, as it
may cause malfunction or damage due to overheating. In this case the
dehumidifier will turn off automatically. Clean the air intake filter frequently and
make sure it is always clean. Cleaning the air filter or filters is vital to the proper
operation of the dehumidifier and the root cause of any problems that may
arise in the future.
Tipping Protection
To prevent overheating, the appliance is equipped with a switch to detect
reversing or falling of the dehumidifier so that its operation is stopped
automatically if it falls down.
E-saving state
Energy saving function (Smart Saving Energy function)
When the appliance drops the humidity levels to the desired level, then the
dehumidification function stops and the fan continues to work for the next 2
minutes. Then there will be a 30 minute downtime. After 30 minutes, the fan will
turn on for 2 minutes, measuring the humidity of the room. If the relative
humidity levels have risen above 5% of the selected relative humidity value, the
appliance will start operating normally. If it has not increased more than 5%
then the device will stop operating for another 30 minutes. These thirty minutes
of shutdown are intended to homogenize the humidity in the room
(evaporation effect), the most accurate measurement of room humidity and
therefore the most economical operation of the device.
