pureHeat GARAGE&PATIO, Owner'S Manual

10

UNIT SETUP - Wall/Ceiling Mount

1 . 

Ensure the desired mounting location can fit the unit in a horizontal orientation and is 
near an outlet but free from electrical cables, communication lines, and pipes that 
could be damaged by excessive heat. 

2 . 

If needed, pre-drill your wall and insert 
3 Wall Anchors. Use Bracket 2 as a 
template for hole placement. 

3 . 

Use Two (2) M6*14 Bolts and Two (2) Acorn 
Nuts to combine Top of Bracket 1 (Long 
End) to the Bottom of Bracket 2 (Short End) . 

4 . 

Use Three Screws (Type will vary based 
on your need) and fasten the Mounting 
Bracket to the Wall in a vertical 
orientation. Use the top hole and the 
outside holes on the bottom. 

5 . 

Use Two (2) M5*12 Screws to install the 
Mounting Bracket to the rear of the 
Heater Body.

FOR YOUR SAFETY, READ ALL IMPORTANT INSTRUCTIONS (PAGE 7) AND USAGE (PAGE 13) 
BEFORE USING YOUR PUREHEAT PATIO.

x2

x2

HEATER MUST BE MOUNTED 

HORIZONTALLY

 OR THE TIP OVER SAFETY SWITCH WILL ENGAGE 

AND THE UNIT WILL NOT OPERATE.

Mounting Sur

face