12
USING PUREHEAT GARAGE & PATIO
Power
pureHeat GARAGE & PATIO starts in Standby Mode when first turned on. The unit has
power but is not actively heating.
To turn the unit on, toggle the Power Switch to “
-
” .
Modes
Changing the Power Mode increases the Heat Output.
P1 is the Lowest Heat Output Mode and P3 is the Maximum Heat Output Mode.
P1
Press the Mode Button once to change to Power Mode 1
(500W)
.
P2
Press the Mode Button again to change to Power Mode 2
(1000W)
.
P3
Press the Mode Button a third time to change to Power Mode 3
(1500W)
.
Pressing the Mode Button once more puts the unit in Standby Mode again.
Timer
While the unit is active, a timer can be set to turn the unit OFF after a desired amount of hours.
Press the Timer Button to change the amount of hours before the unit will shut off. The
time will increase in 1 Hour Increments, up to 24 Hours.
READ ALL IMPORTANT INSTRUCTIONS (PAGE 5) BEFORE USING YOUR PUREHEAT GARAGE & PATIO.
Summary of Contents for GARAGE&PATIO
Page 1: ...Owner s Manual...
Page 2: ...2...
Page 15: ...15...
Page 16: ...16 www GreenTechEnv com...
