13
FILTER REPLACEMENT PROCEDURE
To replace the filter, turn off the water and switch off the ionizer unit by the
mains and unplug it. Then remove the unit from the wall where it is attached.
1. Open the cover of the filter.
2. Pull the upper part of the filter by pressing down gently. Pull the filter away
from the body of the ionizer. The filter should still be connected to the
below trough.
3. The filter should then be easily removed from the below trough.
4. Fit the new filter unit, (with below trough attached) into the base of the
ionizer unit, by pushing the base in first and pushing the filter up into
ionizer unit. Turn the filter until it locks securely.
5. It is recommended that the extended cleaning programmed be run to
check for leaks.
If there are no problems replacing the back pane, then attach unit to wall. In
case of a leak, repeat procedure again from start. If problem persists,
contact the supplier.
After changing the filter, press the "FUN" bottom on the control panel. You
will see the "Cln" on the LCD display; then press the "SET" bottom then
press the " " bottom. You will hear beep-beep sound, which means you
have initialize the filter changing time.
PUSH
1
2
3
4
