11
HYBRID SERIES
| Filtration & Ultraviolet Disinfection All-in-One Unit
valve
4
5
7
8
Replacing UV Lamp
IN
3
Fig. 3
Hybrid R:
Position on the wall. Insert and tighten the fixings to
hold the system securely to the wall. This unit can be installed
from left to right or right to left depending on the water supplies
point of entry.
Note: The outlet is always on the UV side of the system.
6. Turn the water off and purge the lines.
7. Plumb inlet and outlet pipe work to the Hybrid unit. The inlet is a
25 mm female and the outlet is a 25 mm male.
Note: Use thread seal tape, do not use liquid sealants. Never connect
PVC pipe directly to the unit. The outlet pipe work within 1 metre should be metal or
polyethylene.
8. If you have a Hybrid G model, open the cover. If you have a Hybrid R model, proceed
to step 9.
9. Remove the lamp connector from the top nut, if the nut is inadvertently loosened
during this process, retighten the nut. Insert the spring into the ballast by dropping
it into the chamber. Slowly insert UV lamp into chamber through the hole of the
aluminium nut end. Connect the lamp connector to the pins on the lamp. Do not let
go of the lamp until the lamp is connected to the socket (
see Fig. 7
).
Never touch the quartz (glass) and lamp surface as marks or fingerprints may
interfere with UV transmission. If lamp is soiled, please clean lamp with an alcohol
based cleaner.
10. Put safety cap on the aluminium nut end. Connect the
ground wire to the chamber as shown in Fig 4. Plug in
power connector.
11. Use the provided spanner to tighten filter bowl until firm.
DO NOT OVER TIGHTEN.
12. Turn the water on, let the water flow through – opening
a tap downstream to flush the unit for 1-2 minutes. Then
check the system thoroughly for leaks.
Note: For initial use, wait 3-5 minutes to allow water to pass through the whole
unit. Turn on a downstream tap to let water flow through the unit for 2-3 minutes to
release air and impurities from the system.
13. Turn the power on and ensure that the lamp is operating. Make sure that the GREEN
LED is illuminated (refer Lamp Replacement Procedure on pg.14).
14. If you have a Hybrid G model, close and lock the lid. Note: Your cabinet comes with
2 keys for your convenience. Please store them safely as lost or misplaced keys are
not covered by warranty.
Installation Procedure
Fig. 4
Summary of Contents for HYBRID G12
Page 24: ......
