16
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2020
Replacement Procedure
Lamp Replacement Procedure
Prior to performing any work on the UV steriliser, always disconnect the power
supply first.
1 Turn water off and release the water pressure.
Parts become hot during operation.
Allow to cool before servicing.
2 Unlock and open the cover if you have a
Hybrid G model. Disconnect the lamp connector
and ground wire. Grip the end of the lamp and
carefully disconnect the power socket.
Slowly remove the old lamp from the chamber.
3. Remove the packaging on the new lamp. Slowly insert into chamber through the
hole of the aluminium nut end. Connect the lamp connector to the pins on the lamp.
Do not let go of the lamp until the lamp is connected to the socket (
see Fig. 6
).
Never touch the quartz (glass) and lamp surface as marks or fingerprints may
interfere with UV transmission. If lamp is soiled, please clean lamp with an alcohol
based cleaner.
4. Secure the lamp connector on the aluminium nut end. Connect the ground wire to
the chamber. Plug in power connector, the RED LED will be illuminated (when the
lamp life timer is reset in step 6 the LED will turn green).
5. Restore water supply and check the unit for leaks. Re-check the unit after 1 hour.
Note: For initial use, wait 3-5 minutes to allow water to pass through the whole
unit. Turn on a downstream tap to let water flow through the unit for 2-3 minutes to
release air and impurities from system.
1
2
valve
IN
OUT
4
5
7
8
Replacing UV Lamp
valve
IN
3
Cleaning Quartz Sleeve
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
9
Replacing UV Lamp
IN
OUT
1
2
4
5
O Ring
O Ring
Fig. 6
Summary of Contents for HYBRID G12
Page 24: ......
