4
Installation & Operation Manual
Copyright © Puretec Ltd 2020
System Installation
This system comes complete with an installation kit enabling it to be connected to 13 mm
(½”) copper pipe (cold supply only - hot water should be filtered prior to heating). Included is a
control valve incorporating backflow prevention, anti hammer, flow control and pressure limiting
capabilities according to Australian Standards in full compliance with the relevant laws.
Caution: This product must be installed in accordance with local plumbing regulations by a
licensed plumber.
Installation Requirements
1 13mm (½”) cold water line.
2 Supply pressure: 300 - 520 kPa.
3 Supply temperature 0° - 30 °C (protect from freezing).
4 Suitable location for faucet.
Alternative fittings may be required if being connected to anything other than 15 mm (½”)
copper pipe. No electrical or drainage requirements needed.
Parts Included
System Installation
RO System Faucet MC051 Cartridge CB951 Cartridge RO Membrane
Tank Spanner Multivalve Drain Clamp SmartTee
TM
Shut Off Valve
