10
Step 1: If wiring was routed from
inside of the box of the truck,
bring the wiring down to the
bottom of the box. There is a red
wire, purple wire, and orange wire,
in addition to a two-conductor
cable with red and black wires
for the door sensor. If wiring was
routed outside of the box truck
all the way to the back, a hole
will need to be drilled in the area
described (very back of the box by
the door rail).
Step 2: The red and purple wires
should have the mating connector
to the key switch added (wires
have been preterminated). Then
connect the two connectors
together. Use supplied clamps to
reinforce routing of wire.
KEY SWITCH/DOOR SENSOR WIRING
Installation Complete.
Note:
All wires have been preterminated to eliminate crimping.
Extra
terminals have been supplied in case terminals are damaged during wire/
cable routing.
Summary of Contents for SafeFreight
