6
SCYLLA ELECTRIC ROBE WARMER (EXPOSED CABLE)
FITTING INSTRUCTIONS
Scylla Electric Robe Warmer (Exposed Cable) • 2022-04-01
GB
6. CLEANING
Any hard scrubbing or scratching to the product surface will
result in damage to the surface of the robe warmer. The use
of any cleaning products which contain acid or corrosive
agents will also damage this product. For best results use a
cream cleaner.
Cleaning should be done using a damp soft cloth.
7. END OF LIFE DISPOSAL
Products with the crossed out wheelie bin symbol can-
not be disposed of as household waste. Old electrical and
electronic equipment must be recycled at a facility capable
of handling these products and their waste by-products. If
you are purchasing replacement equipment your retailer
may offer a take back scheme, or be able to give details of
the nearest approver authorised treatment facility. Proper
recycling and waste disposal will help conserve resources
while preventing detrimental effects on our health and the
environment.
5. OPERATING INSTRUCTIONS
The robe warmer power feed isolation switch is switched ON
and OFF by pressing the switch on the bottom right hand
upright (Fig 6).
Fig 6 ON/OFF switch
To operate the robe warmer, switch the red power feed but-
ton to “ I “ . The heater can now be switched on by pressing
the ON/OFF switch on the timer control panel on the front
of the robe warmer. The heater will remain on until the ON/
OFF button is switched off.
To use the 2-4 hour timer, switch the ON/OFF button
1
to
“ON” , then press the 2-4 hour timer button
2
. Press once
for 2 hours or twice for 4 hours. A small blue light
3
under
the 2 or 4 hour indicator will light up to confirm the time you
have chosen. The robe warmer will now remain on until the
time selected has passed, then rail will then automatically
switch off. The rail can be switched off at any time by pres-
sing the ON/OFF switch.
1
ON/OFF button
2
Button for 2-4 hour timer
3
Indicator light for 2-4 hour timer
Fig 7 Timer control panel
o = OFF
I = ON
2
3
1
