Changing the world one Vehicle at a Time
K. SPEED SETTING SWITCH – 3 SETTINGS
Your Pushpak can travel at a maximum speed of 18 MPH. The speed setting switch regulates your
top speed for safety.
CAUTION
Release of the throttle does NOT engage the braking system. T0 entirely stops the
Pushpak from moving, and you engage the brakes.
c. In addition to the speed settings, the current speed of the Pushpak within each speed setting can
be regulated by adjusting the amount of roll of the throttle. Full roll to the throttle's stopping
point allows the Pushpak to travel at the maximum speed within each speed setting
V.
TURNING
In the United States, bicyclists are required to use hand signals to alert surrounding traffic of their
intention to turn or change lanes. Your Pushpak is equipped with left and right turn signals which may be
used in place of hand signals for this purpose. If you opt not to use the turn signals, you must instead use
proper hand signals.
a. No Signal – The turn signal switch should be in the center OFF position when not in use.
b. Left Turn/Lane Change – Before making a left turn or lane change, move the turn signal switch to the
left. The front and rear left turn lights will blink, and a beeping sound will be audible. Move the turn
signal switch back to the OFF position once you have completed your turn or lane change.
c. Right Turn/Lane Change – Before making a right turn or lane change, move the turn signal switch to
the right. The front and rear right turn lights will blink, and a beeping sound will be audible. Move the
turn signal switch back to the OFF position once you have completed your turn or lane change.
CAUTION
29
