INSTALLING THE CENTRAL VACUUM CLEANER
There are detailed instructions on how to mount the Puzer dust piping system and
suction outlets. These instructions are included in your piping system delivery.
1. Fasten the filter unit
with four screws to
their correct locations.
Use wall brackets
depending on the
material.
2. Tighten the faste-
ning screws.
3. Fasten the connec-
tor of the weak current
wire to the counter
piece of the filter unit.
The connector of the
weak current wire can
be found separately in
the package.
4. Push the central
unit directly towards
the filter unit. Push the
central unit toward the
filter unit.
9. Fasten the weak
current wires and the
mains cable to the
circuit board of the
machine.
5. Place the central
unit directly towards
the filter unit. Make
sure that the rubber
pieces behind touch
their counterpieces.
6. Put the latches to
their correct places.
Support the central
unit with your other
hand so that it will not
fall.
7. Push the latch
all the way to the
bottom.
8. Place the other
latch to its place.
Repeat points 5 and
6.
INFORMATION
In case you need any help with planning and installing your central vacuum sys-
tem, please contact the dealer or the manufacturer in the following address.
Manufacturing and marketing:
KP-TEKNO OY
Masalantie 365, 02430 Masala, tel.+358 9 296 5070, fax +358 9 221 5932
e-mail: puzer@puzer.fi, www.puzer.fi
4
