Operation and Maintenance Manual Rev M(ii) 4/03
- 10 -
Introduction
System Description
The workcell has been designed specifically for applications involving industrial dispensing and conformal
coating. The flexibility of the machine allows it to be used effectively for a wide range of applications.
The valves are mounted to the end effector of a two, three or four axis Cartesian robot. All dispensing /
spraying is performed within the lexan enclosed work area. Limits have been imposed on the axes to
prevent damage to the machine. The dispense / spray path and active heads are controlled by a program
stored in the motion controller. The controller can store and retrieve up to 30 programs.
NOTE: Not all models are equipped with lexan guarding.
The operator interface permits the operator complete control of the machine. This includes machine setup,
manual operation, program selection and automatic operation. Machine status and error messages are
displayed on the LCD screen and via the optional light tower. It is necessary that operator(s) have read or
by training understand the operation of this machine.
Any uses other than listed above could result in a dangerous condition and cannot be protected against by
the safety features installed on the system.
Figure 1 – workcell Functional Block Diagram
Year 2000 Compliance
The workcell is compliant with and comprehends the year 2000 century date change. The workcell will not
have any operational impediments, malfunction, cease to perform, generate incorrect or ambiguous data
and/or produce incorrect or ambiguous results with respect to same-century and multi-century formulas,
functions, date values and date-data interfaces.
Summary of Contents for PVA2000
Page 9: ...Notes ...