Pro Video Instruments
Vecoax Compact RF series modulator Manual
16
VID QUAILTY MODES
The Vid Quality modes on the unit determine the speed and size of information sent
to your TV’s tuner decoder.
The default is LOW LATENCY.
Only if you experience any
image issue on the TV should you change this setting. Using the other options
available such as HIGH or Average will only change the speed the information is given
to the TV to be able to decode the picture properly ( For slower Television tuners and
models )
LOW LATENCY -
This mode is the fastest in terms of information sent to the TV. It
sends frame by frame which will give you the best picture and ultra-low delay for
applications that require constant use of the HDMI Source menu system such as Cable
provider boxes or DVD players.
AVERAGE
–
This is a good balance between lower latency and speed of information
sent to your TV’s tuner. This mode sends the Information in smaller
chunks rather
than instant refresh rate which helps with slower TV tuners that have slower/smaller
decoder memory. This form of chucks can help give a very slight increase in image
quality due to the Tuner having time to decode each picture at its own pace.
HIGH -
This mode sends the Information in Lager chunks than Average mode which
again can help with slower TV tuners that have slower/smaller decoder memory. This
form of chucks can help give a very slight increase in image quality due to the Tuner
having more time to decode each picture at its own pace before the next set of chunks
are received.
Note:
A higher delay will occur with these modes due to the delivery of the
information to the tuner in form of chucks rather than picture by picture.
