Pro Video Instruments
VeCOAX MicroMod 3 AV + HDMI RF Modulator Manual
11
ON BOARD DISPLAY - ATSC
These are the Defaults and Good
starting point for
PLUG N PLAY
setup.
If you have more than one unit
please ensure you change the
FREQUENCY
,
MAJOR/MINOR
, and
SHORT NAME
so they don’t
overlap and create issues.
With the above default, the unit
outputs on 473 MHz as channel 1.1.
•
SOURCE
–
Set your Video Source as HDMI or CVBS.
•
STANDARD
–
Set your TV standard depending on
your needs, location, and support format of your TV.
•
FREQ
–
Set your Frequency using our ATSC
Frequency chart starting on page 36. TVs will scan for
the Frequency, then store the channel as the
Major/Minor channel number you have set on the
Unit.
•
VID QUALITY
–
Set the Latency Mode of your Video.
•
MAJOR CHANNEL
–
This is the Major channel
number that will be displayed and stored in
the TV’s
Virtual Channel Table (VCT). (For example, for
channel “10.1”, “10” is the Major channel number.)
•
MINOR CHANNEL
–
This is the Major channel
number that will be displayed and stored in
the TV’s
Virtual Channel Table (VCT). (For example, for
channe
l “10.2”, “2” is the Minor channel number.) If
you wish to have many channels with the same
Major number, use the Minor number to
differentiate.
•
SHORT NAME
–
Name of the Channel you wish to
use. 4-6 Characters max depending on TV.
•
AUDIO FORMAT
–
Set your desired Audio Format.
AC3 is the Default Standard for ATSC and QAM
mode.
•
ADVANCED
–
Advanced options for users who
require Specific PID’s or Fixed EDID information.
Please don’t change these
unless you understand
your required PIDs or EDID per Cable Provider
instructions or PVI Tech Support request.
