2.
Connection Drawing
2.1 Matrix configuration
IGMP POE switch
【
NOTE
】
:
The POE switch has to support IGMP function
2.2 Point-to point configuration
3. IR use guide
3.1 IR passback
IR blaster extension cable should plug into the IR-out port of TX
(Transmitter) of this extender matrix, and the IR receiver extension
cable should plug into the IR-in port of the RX (Receiver) of this
matrix extender. The emitter of IR blaster should as close as possible
to the IR receiver window of the signal source device.
3.2 IR remote control
Using the IR remote controller to set/select the channel of this
HDMI Extender Matrix.
