DESCRIPTION
PARAMETER
To set the cutout point of the
Compressor.
To set the cutout point of the
Compressor.
To set compressor restart delay.
To set temperature differential for
compressor restart.
To set maximum allowable high
temperature limit & alarm.
To set minimum allowable low
temperature limit and alarm..
To enable or disable Antifreeze
function.
To set Antifreeze tripping point.
To set Antifreeze resetting differential.
To set Main(Liquid) probe calibration.
To set Antifreeze probe calibration.
To set tripping voltage of digital inputs .
To set LP fault sensing delay.
CHILLER SET TEMP.
To set other parameters.
CHILLER SET TEMP.
COMP TIME DELAY.
DIFFERENTIAL
HI TEMP. ALARM
LOW TEMP. ALARM
AFTPROBE STATUS
AFT SET TEMP.
AFT DIFFERENTIAL
LIQ. PROBE CAL.
AFT PROBE CAL.
FAULT SENS LOGIC
LP SENSING DLY
Pg.
No.
PROGRAM MODE
SET MODE
05
05
05
06
06
06
07
07
07
08
08
08
09
09
INDEX
INDEX
To set LP fault to Auto or Manual reset.
LP FAULT RESET
To enable / disables liquid level
sensing.
LIQ. LEVEL SENSOR
To configure pump working logic.
PUMP RUN LOGIC
To configure Relay3.
RELAY3 LOGIC
To lock keypad.
KEYPAD LOCK
Revert to factory set parameter.
FACTORY SET
To end programming
SET - EXIT
Wiring Diagram
Panel Cutout & Dimensions
Technical Data
Installation & Maintenance
09
10
10
10
11
11
11
12
13
14
15
DESCRIPTION
PARAMETER
Pg.
No.
03
04
To set HP and AFT fault to Auto or
Manual reset.
HP/AFT RST
09
NC-110
NC-110
Key Introduction
11
