2
Safety conditions
The PX385 is a device powered directly from power grid 230V, what may
result in electric shock in case of not following safety rules. During its
installation and use the following rules must be strictly observed:
1. The device should be installed as described in the manual.
2. The installation to which the switch is connected have to be linked to a
working protective installation (3-wire installation).
3. Protect the power cord from mechanical and thermal damage.
4. In case of damage the power cord, replace it with the same technical
data.
5. For connecting devices to the Relay Module use only 3-wire cables
with cross-section of not less than 1,5mm
2
.
6. All repairs and connections of outputs or DMX signal can only be
made with cut off power supply.
7. PX385 should be strictly protected against contact with water and
other liquids.
8. All sudden shocks, particularly dropping, should be avoided.
9. Do not connect to a power supply with a damaged case.
10. The device cannot be used in places with temperature lower than +2°C
on higher than +40°C.
11. The device cannot be turned on in places with humidity exceeding
90%.
12. Use only a slightly damp cloth for cleaning – the device must be
completely disconnected from the power supply at this time.
4
