3. Set the
ninth
DIP switch to
OFF
when you want the driver to work in
the 0 – 10V mode or
ON
for the 1 – 10V (Relay).
4. Save your settings by switching the
tenth
DIP switch to
OFF
which will
take you to the addressing mode.
5. Set switches DMX address of the device with 1 – 9 (switch 10 must be
OFF
then).
NOTE! If the user intends to configure the device using PxArt+ Settings
Controller or using the RDM protocol, all DIP switches should be set to
OFF
.
5.2 Configuration using PX277
Converter settings can be changed by plugging in the PxArt+ Settings
Controller.
When connecting the cable to PX385, the device restarts. The main menu
of the configurator allows for viewing PX385 parameters and changing the
following options: brightness address, scene brightness, output mode and
restoration of default parameters.
Moreover, it is possible to check the lighting time (control time) and
working time (triggered voltage). PxArt+ Settings Controller also allows for
checking the software version number, serial number and device model.
Navigating through the menu is possible with programmer buttons
located below the display. The
escape
button allows an exit to the upper level
in the device menu,
next
and
previous
buttons make it possible to go forward
and backward (alternatively value decreasing or increasing). However, the
enter
button allows to enter the edition of the selected menu.
8
