5.2.3 Scene brightness
The device can work without DMX control. In such case, the PxArt+
Settings Controller enables the value of the scene brightness. This value can
be set in the range from 0 up to 255.
[Scene bright.] set to value 0 turns off the stage and turns the value 255 to
100%. Value 128 means the stage
brightness is 50%. After changing the
value of the stage brightness, the
operation has to be confirmed by pressing
enter
or
escape
.
5.2.4 Output modes
The PX385 device can operate in two output modes:
•
0 – 10V
•
1 – 10V – Relay mode
Using the PX277 configurator enter the submenu [Out mode] and using
the
next
and
previous
buttons select the
output mode according to the wiring
diagram. After changing the mode
confirm the operation by pressing
enter
or
escape
.
10
Model
PX385 0-10V
ENTER
Scene bright.
128 *
NEXT
Scene bright.
128
Scene bright.
255 *
2 x NEXT
PREV
Scene bright.
000 *
Model
PX385 0-10V
ENTER
Out mode
0-10V *
NEXT
Out mode
0-10V
Out mode
0-10V + RELAY *
3 x NEXT
