5
Control
5.1 Buttons
The lamp has been equipped with buttons which allow for changing the
brightness level and color temperature of light. The buttons have been placed
at the bottom part of the junction box, above the lamp reflector. One button is
responsible for one parameter.
Depending on a situation, the diode signals the following:
•
start of the lamp – quick flickering of the diode for 2 seconds
•
DMX signal receiving – slow flickering of the brightness adjustment
button (1Hz frequency) in the first minute after receiving the DMX
signal
•
after the start of the lamp in case of the loss of DMX signal – diode
lights (continuously) for 1 minute
•
if the state of DMX signal changed (if there wan no DMX signal and it
returned, or vice versa) – diode signals it for 1 minute
•
damage of the temperature sensor module – diode does not go out
after 1 minute
To change the brightness or temperature color, press and hold down the
appropriate control button. If during the brightness or color temperature
adjustment the button diode starts flickering, it means that the extreme value
(minimum or maximum) has been reached.
7
