INSTALLATION
1.
Press the switch under the headrest of the car seat and pull out the headrest.
2.
Combine the base B (2) and the base A with steel ripple pipe (1), then place them
on the poles of the removed headrest to select proper hole position to install the
base.
3.
Remove the Base from the headrest and loosen the two screws by using the
screwdriver, then according to the size of the poles, place the two plastic tubes
( 13mm) (3) or plastic tubes ( 16mm) (14) on the holes that you just selected,
then adjust them to proper position as shown in diagram below.
Headrest
Switch
(3) Plastic tube( 13mm)
or (14)Plastic tube( 16mm)
(1)
Steel ripple pipe
(2)
10