www.PyleUSA.com
4
4. POWER INDICATOR
This indicator lights up when the internal switching power supply is activated
and the unit is operational.
5. LEFT/RIGHT HIGH IMPEDANCE INPUT
To be connected to output of source unit.
6. LEFT/RIGHIT LOW IMPEDANCE INPUT
If RCA output is not available, connect speaker outputs of signal source to this
input.
7. HIGH-PASS FREQUENCY SELECTOR
For selection of high-pass crossover frequency between All Pass, 80Hz, 100Hz
and 125Hz.
8. HIGH-PASS FILTER SLOPE SELECTOR
6 dB:
When the high pass crossover frequency is set close to the speaker's
resonant frequency, where the response rolls off at a rate of 12 dB per octave,
switching the selector to the “
6 dB
” position would produce the ideal 18 dB
odd order type phase response.
18 dB:
When the crossover frequency is set away from the speaker's resonant
frequency, switch the selector to the “
18 dB
” position for ideal 18 dB odd order
type phase response.
9. HIGH-PASS OUTPUT LEVEL CONTROL
For adjusting the high-pass output signal level.
10. LEFT/RIGHT HIGH-PASS OUTPUT TERMINALS
To be connected to the mid/tweeter amplifier left/right inputs.
11. LOW-PASS FREQUENCY SELECTOR
For selection of the low-pass crossover frequency between 50 Hz, 63 Hz,
80Hz and 100 Hz.
12. LOW-PASS OUTPUT LEVEL CONTROL
For adjusting the low-pass output signal level.
13. LEFT/RIGHT LOW-PASS OUTPUT TERMINALS
To be connected to the woofer/subwoofer amplifier left/right inputs.
Summary of Contents for PLXR2B
Page 1: ...2 Way Electronic Crossover Network Independent High Pass Low Pass Output Level Controls ...
Page 5: ...www PyleUSA com 5 SYSTEM DIAGRAM Remote Turn On Lead from Head Unit Battery Positive B A B ...
Page 13: ...www PyleUSA com 13 ...
Page 14: ...Questions Issues We are here to help Phone 1 718 535 1800 Email support pyleusa com ...
